USC 26006 Icing 24 oz tube - Glazing & Finishing Filler Putty

Description

DESCRIPTION:
Icing® Pourable Brushable Polyester Finishing Putty is the original, best selling polyester finishing putty that
spreads smoothly, self levels, and dries to an exceptionally easy to sand finish. Icing provides great adhesion and
is tack free and stain free.
PRODUCT USES:
Use for minor body work and surface imperfections (1/8” thick or less) such as sand scratches, chips, scratches and
pinholes. Ideal for use as a finish coat over body filler
TYPICAL SUBSTRATES:
● Metal ● Aluminum ● Fiberglass ● Body Filler ● Wood ● 2K Primers
● Aged, sanded OEM Topcoats ● Galvanized and other zinc-coated steel
● SMC – can be used for cosmetic repairs. For structural repairs prone to high degrees of stress and flexibility,
use an SMC repair product.
SURFACE PREPARATION:
1. Clean surface. Remove all dirt, oil, grease and wax with a cleaning solvent such as 1240-1 Wax,
Grease & Silicone Remover.
2. Make sure surface is dry before repairing.
3. Use 80 – 180 grit disc to featheredge paint for good mechanical adhesion.
MIXING:
For best results, bring putty and provided hardener to room temperature (minimum temperature 68ºF).
Knead hardener tube before use. Place a 4” diameter puddle of putty on a clean mixing surface (we
recommend a non-absorbent plastic mixing board) and add a ribbon of cream hardener from edge to
edge across the center of the putty puddle (puddles larger than 4” will require additional hardener); or
measure hardener at 2% by weight – a 50-1 ratio. Mix thoroughly with a plastic spreader, using a folding
motion, until uniform color is achieved. At room temperature (68ºF) approximate setting time is 3-5
minutes.
APPLICATION:
1. Using a plastic spreader, apply a thin layer of putty to surface, using firm pressure for maximum
adhesion.
2. Apply additional layers, building up damaged area higher than the surrounding surface to allow for
sanding of the putty. Do not apply over fresh or uncured coatings.
FINISHING:
When material has hardened, in approximately 15 minutes, sand with 100 - 180 grit sandpaper followed by
220 - 400 grit if desired.
TOPCOATING:
May be topcoated with polyester, 2K urethane or 1K primer. Refer to paint manufacturer’s instructions for topcoat
application.
SPECIAL NOTES:
May be intermixed with any USC Body Filler product except All-Metal.